Tape Support

Last updated 4 months ago

Tape Support


The diagram below illustrates the main components and processes within the backup infrastructure when tape support is implemented in Veeam Backup & Replication:

Tape Device Connection

The following configuration prerequisites must be met:

  • All connection types require driver installation

  • You can use generic drivers from Microsoft Windows, but they may not provide as high performance as the vendor’s

  • Separate drivers for tape drives and for tape media libraries should be installed

  • StorageTek ACSLS is not supported while a direct connection to the library is

  • Dynamic Drive Sharing is not supported

  • Library Partitioning is supported

  • Multiple control paths are supported only when control path failover and MPIO is configured correctly. Please contact the vendor for more information.

Connection Type Compatibility

  • FC/SAS/SCSI/FCoE/Infiniband/iSCSI or other block technology to physical Tape Proxy Supported with Windows driver as long as the tape vendor supports the connection. (“Unknown media changer” support for FC/SAS and VTLs)

  • FC/SAS redirect to VMware VM Unsupported

  • FC/SAS redirect to Hyper-V VM Unsupported

  • FC/SAS to iSCSI Converter/Bridge Supported

  • Starwind Tape Redirector Supported

Tape device support

While the system requirements dictate what tape devices are technically supported, there is a community validated list available on the Veeam forums: Unofficial tape device compatibility list


  • LTO-3 or higher

  • For VTLs, see the corresponding section under Deduplication Storage

Not supported

  • IBM "Jaguar" TS11x0 Enterprise tape drives

  • StorageTek T10000 tape drives

  • Older Tape drives like DLT or AIT


  • HP drivers: these are not installable with the downloaded install .exe file on a VM (for example, to use with VTL). As a solution, run the install .exe and choose Extract. Use Device Manager –> Update driver and select the drivers for tape drives and (if you use HP/HP emulation tape library) for media changer.

Unknown Medium Changers:

Veeam supports medium changers that have no Microsoft Windows drivers available. Make sure that such device is recognized as an unknown medium changer in the Microsoft Device Manager list.

It is recommended that you use tape devices with original equipment manufacturer (OEM) drivers. Limitations VMware does not support tape drives connected directly to ESX(i) 4.x and later. For more information, see VMware vSphere Release Notes.

For more details and recommendations on configuring vendor-supported tape drives and media changers on ESX/ESXi, refer to VMware documentation at http://kb.vmware.com/kb/1016407.

Note: Veeam Backup & Replication uses the MTF (Microsoft Tape Format) industry format to write data to tape. Veeam Backup & Replication does not support using WORM (Write Once Read Many) tapes.